Subnautica in SE Atlas Submarine Seamoth & Prawn 2.0 (Modded)(DLC)
Фото и видео: 1 из 17. Материалы автора из Steam Workshop.
О материале
«Subnautica in SE Atlas Submarine Seamoth & Prawn 2.0 (Modded)(DLC)» — материал мастерской Space Engineers. Моды, чертежи кораблей, скрипты и миры для Space Engineers. Данные Steam, описание автора и ссылка для установки через подписку. Совместимость редакцией не проверена.
Описание автора
PLEASE READ THE INSTRUCTIONS FOR THE BEST EXPERIENCE!
This a complete ground up rebuild of the unused Altas Sub from Subnautica. My first version was very inaccurate and loosely based some early drawings. This one is much more accurate to the mod for the game. There is also a Seamoth and Prawn Suit in the Docking Bay.
Everything has been carefully programmed to make it as close to the same functionality found in Subnautica. This is a World file so I don't have to link all the mods. After you load the world you can save and back out to the settings to find it. I'll post a screenshot with the list also.
Known Issues- First and foremost, the are two scripts that need to be recompiled and run on each world load. Nothing I can do about it. The programmable blocks with these scripts can be found in a server closet behind the bridge on the port side. Behind the small hangar doors. They are the AutoLevel & Shield Status scripts. They are labeled. This needs to be done first. If you find yourself in the cockpit and the sub won't move. Open the PB - AutoLevel "edit" tab for a second and exit back out. Run it again via the hotbar. This goes for all the Vehicles.
Second, Hinges! What can I say. Sometimes they just get stuck. It doesn't happen often, but it does happen. Notably the external hatch below the bridge and the fabricator.
As for the rest there are signs throughout to warn you if needed.
After you've reset those PBs go to the bridge console on the port side and press the power on button. There is also one located in the engine room.
You're now online.
Hotbar page 1
1- Reverse standard 2- Reverse slow 3- All stop 4- Ahead slow 5- Ahead Standard 6- Emergency Speed WARNING! Don't run the engine too hard and overheat it! 7- 8- Rig for Silent Running 9- AutoLevel
Hotbar page 2
1- Shield Up 2- Shield Down 3- Sonar On/Off 4- Spotlights On/Off 5- Horn 6- 7- Fire/Detach Harpoon (this works as an Anchor) 8- Harpoon Reel in 9- Reel Out
Hotbars 3+ have various subsystem controls which can also be found on button in the bridge.
Hotbar page 9 has manual controls for the up and down thrusters to ascend and dive.
1- Down+ 2- Down- 3- 4- Up+ 5- Down- 6- 7- 8- View Periscope 9- Activate Periscope
Launching the Seamoth and Prawn Suit is automated and just needs to be activated once in the cockpit(s). Keep in mind Subnautica is played solo. Even though this sub is sized for a crew of 4 it's only setup for a single operator. Meaning only one (Seamoth OR Prawn) should be launched at a time. Trying to launch both will bug the timer automation.
The two buttons above them activate the hatch (mini hangar door) to get in. One to open the other to close. Then it's just a matter of activating the TB on the hotbar.
Note: don't forget to reset the AutoLevel if needed once you've launched.
Seamoth hotbar page 1
1- Open access hatch 2- Activate Torpedo Launchers 3- 4- Speed setting 1 5- Speed setting 2 6- Speed setting 3 7- 8- Gyro Override On/Off 9- AutoLevel
Seamoth page 9 1- Activate Launch/Docking Sequence 2-8 9- Docking Rotor attach
Prawn Suit hotbar page 1
1- AutoLevel 2- 3- Spotlights On/Off 4- 5- Stop Walking 6- Reverse 7- Stand 8- Start Walking 9- Jump The walk functions are also setup to work with W/S and [space] for walk forward/reverse and jump.
Note: In the Prawn Suit. If you've had to reset AutoLevel it may have bugged the Gyroscopes. Select all 4 Gyros and deselect override while the AutLevel is running. Once you find the one Gyroscope it's not using (override will stay off) set it's power to 20% and you are good to go.
Prawn Suit hotbar pages 3-8 has various controls for the arms. You may have to reset the hinge limits because they will reset once you start walking. I'm working on a fix.
Prawn Suit hotbar page 9
1- Activate Launch/Docking Sequence 2- Open access hatch 3- 4- Up thrusters manual On/Off 5- Up thrusters manual power + 6- Up thrusters manual power - 7- 8- 9- Docking Rotor attach
Lifepods
These are pretty easy to figure out. One buttun to reopen the door if you need to get back in the sub. One button to eject the pod from the sub. There's no seal between the sub and the pod so if you're below 500m be quick. Opening that door will depressurize the compartment.
I think that covers everything. I hope you all enjoy. This was a lot of work. I'll try to get all the links for the mods and scripts list ASAP. Thanks.
Original Mod for Subnautica. https://www.artstation.com/artwork/RZgEE
Because Steam YouTube Player can be sketchy:
https://www.youtube.com/watch?v=3wxLLmijyXo&ab_channel=HELRATZ96
https://www.youtube.com/watch?v=dtsZhlc0cWw&ab_channel=HELRATZ96
https://www.youtube.com/watch?v=ptAqq-j8Jnk&ab_channel=HELRATZ96
https://www.youtube.com/watch?v=PjALYuPLzVA&ab_channel=HELRATZ96
https://www.youtube.com/watch?v=uhnyRApyiV4&ab_channel=HELRATZ96
Fixes 10-6-2020
- Added buttons in lower docking bay to manually control doors if timers become bugged.
- Added safety sensors in docking bay to prevent doors closing if you try to launch both Seamoth and Prawn. (You will still have to manually unlock and open the bay doors after docking one of two vehicles if both have been launched)
- Corrected Engine Critical Failure not resetting when switching from emergency speed to all other speed modes.
Special Thanks to LSG for bringing these issues to my attention after showcasing this build.
Как установить и запустить
Откройте оригинальную страницу в Steam Workshop, проверьте версию игры, зависимости и порядок загрузки в описании автора. Нажмите «Подписаться» и дождитесь загрузки Steam. Включите материал в меню модификаций или контента игры, если это требуется. Совместимость и запуск редакцией не проверены.