Поиск по STEAMB

Игры и программы по онлайну, скины по объёму продаж

Ничего не найдено

Попробуйте другое название или переключите категорию.

Меню

МодыБлоки

Rotor Part - easy manual attachment

Положительные голоса97%64 голосов игроков
Подписчики1,7 тыс.1 653 в Steam Workshop
Размер файла114,69 КБЗагрузка через Steam
Обновление автора9 дек. 2017 г.Дата обновления материала

Фото и видео: 1 из 10. Материалы автора из Steam Workshop.

Фото и видео: 1 из 10
Установить через Steam

О материале

«Rotor Part - easy manual attachment» — материал мастерской Space Engineers. Моды, чертежи кораблей, скрипты и миры для Space Engineers. Данные Steam, описание автора и ссылка для установки через подписку. Совместимость редакцией не проверена.

Описание автора

Enables (experimental) build assist to directly building upon a rotor head or rotor base (stator), or suspension base with any wheel size.

Also enables the following hidden cubes to allow building with directly:

  • Rotor Part
  • Advanced Rotor Part
  • Real Wheels (all sizes, both sides)
  • Piston Top (not that you can reconnect these, yet...)

To place a different sized block, hold down shift when placing it. This allows interesting combinations such as:

  • put a small rotor head onto a large rotor base.
  • put a large rotor base onto a small head. (yes, reverse!)
  • put a large grid wheel (1x1, 3x3 or 5x5) onto any small other small grid suspension.
  • put a rotor head on a suspension (it does work, but you don't get the benefits of a real wheel, like traction and torque).

Note: putting wheel onto a suspension requires you to get close to the suspension with the builder cube highlighting the suspension in the red box. This usually works best from the front, but you will be pushed back when the wheel spawns.

This is one of those few mods you don't have to leave in your game world when publishing to the Steam Workshop, as the cubes remain attached in your saved game regardless.

Build hints: If you are building two 'Rotor's facing one another like a hinge at opposite corners of a door to provide more stability, then set both Rotor Offset's to -20.0cm for a Large Rotor, and -8mm for a Small Rotor. Also, make sure both 'Rotor's have their 0 degrees facing the same direction. When you place the Rotor Parts, also make sure they have their 0 degrees facing the same direction. This will prevent them from exploding when putting them all together.

Видео автораОткрыть в YouTube ↗
Видео автораОткрыть в YouTube ↗
Видео автораОткрыть в YouTube ↗
Оригинал в Steam Workshop

Как установить и запустить

Откройте оригинальную страницу в Steam Workshop, проверьте версию игры, зависимости и порядок загрузки в описании автора. Нажмите «Подписаться» и дождитесь загрузки Steam. Включите материал в меню модификаций или контента игры, если это требуется. Совместимость и запуск редакцией не проверены.

Настройки cookies

Вы можете изменить выбор в любой момент. Отказ от аналитики не ограничивает доступ к сайту.

Технологии, провайдеры и сроки хранения