Orbital Elevator/Tether
Изображение 1 из 6. Материалы автора из Steam Workshop.
О материале
«Orbital Elevator/Tether» — материал мастерской Space Engineers. Моды, чертежи кораблей, скрипты и миры для Space Engineers. Данные Steam, описание автора и ссылка для установки через подписку. Совместимость редакцией не проверена.
Описание автора
Orbital Elevator/Tether (World) (Vanilla)
THIS IS A WORLD LOAD, NOT A BP/BLUEPRINT
---Disclaimer--- It is suggested that you save regularly as this build is rather finiky and may explode due to random reasons and not just due to memory usage. Autosave is off, FYI, view distance is also 5km for performance sake. I will attempt to give the best directions on how to operate this device but may not adequately do so for some or all people. Also, technically, I would need another 21km of elevator to escape the gravity well but the game said no, so 0.24G is what you get.
---HOW TO USE---- (HIGHLY RECOMMENDED THAT YOU READ THIS PRIOR TO USE!!!) You will load in at the base of the Elevator, there is a med station there as well if you set the world that way. You can either take the piston gantry over to the elevator car or fly, pretty much everything else on the actual elevator serves no purpose at this time. The elevator car only has 1 tab of buttons set, these are
- Decrease Power (Wheels) - Default 0% (DO NOT EXCEED 30%)
- Increase Power (Wheels) - Default 0% (DO NOT EXCEED 30%)
- Camera (Up Facing)
- Camera (Down Facing)
- Empty
- Aero Thrusters (Centered Ones) - Default ON
- Aero Thrusters (ALL) - Default ON
- Ion Thrusters (ALL) - Default OFF
- Gyro's (I recommend keeping them off as BAD THINGS CAN HAPPEN) - Default OFF
W Key for Upwards movement S Key for Downwards movement
To go up the elevator (relatively easy) -Increase wheel power to 20% and while keeping (7) and dampers on. -After a couple of seconds increase power to 25-30%, the key thing is to make the acceleration kind of slow but mostly steady. You should not pass 250km/h for the first 750m. Turn off (7) and dampers once you pass 100km/h. -The rings on the elevator mark distances with the first marking the first 55m above ground, the second 250m past that, and each subsequent one 1km. -At about 10km turn (8) on but not dampers. -Continue up the elevator till you reach the last set of rings, this marks the last 1km of rail. This should be easy to tell if the GPS points are showing but if they are not then at elevation 20,000m on your HUD in the cockpit. -At the last set of rings let go of the W KEY and turn dampers on. If you did this right you should stop about 200m from the end of the elevator. It is 0.24G at this height. -You can take the car the rest of the way up or mess around at this point. I suggest that you save at this point if you made it here without suddenly exploding. I also suggest that you leave the cockpit before going back down, if only that the car seems more stable when I have done so.
Going Down the Elevator (MUCH MUCH HARDER, likes to explode at the end for some annoying reason if you get impatient) -Decrease wheel power to 15% and keep (8) and dampers ON -Start going down the elevator, the key point is again having a slow-mild smooth acceleration. You should play with the wheel power settings as you should not pass 250km/h for the first 1km. -Once you reach 375km/h you can turn (8) off but keep dampers ON. Stop holding S as well, in free fall at this point, no additional propulsion required. -Now come the hardest part, at 200m from the elevator base (I would recommend anywhere from 75-100m optimal but at speed it is hard to that point without making a crater) press and hold SPACE till you are creeping down the elevator. You should be be at somewhere about 100-200m above the the elevator base. -While still holding SPACE, turn (7) on. After doing that you can let go of SPACE. You should be going 0.5km/h at this point. Patience is key at this point. -For however much distance you have left till contact with the supports for the elevator car and where you are you are going to pulse the (6) key ON/OFF. DO NOT let your speed get above 10km/h, DO NOT leave the cockpit, and DO NOT start operating moving objects that you might have attached to the vehicle UNTIL it is safely settled onto the supports. -At this point you should reset the keys to the above defaults and leave the vehicle. Also saving is suggested.
Adding things to the elevator car The exact center of the elevator and car are aligned to gravity. You must balance the mass on the car otherwise things will most likely explode. Other than that, go wild.
---SOME SUGGESTED SETTINGS--- While it great to turn your settings up just to get a sense of scale, I have encountered issues where Tether car has bugged out and self-destructed due to sudden load peaks. Thus I would recommend having your graphics and world setting set for best performance but this is only a optional suggestion and that people with monster gaming computers might not experience such things.
---DESCRIPTION--- This was creative built 21,305m* tall Orbital Elevator/Tether (choose the terminology that you prefer), and was tested in both creative and survival mode. Comes with a basic 'Electric Tether Car Mk2r2'. Takes about 4mins to traverse a distance of 21.305km with max speed of 375.6km/h (104.3 m/s). Completely powered and moved via electric power with the primary propulsion being done via 3x3 suspension wheels with aero/ion engines for fine control and emergency stopping.
The rails are made of light armor blocks to save on building costs which are rather ridiculous**. These do have binding rings mostly every 1km for ensuring that if one rail breaks it does not take the rest of its upper self with it***/****. There is no end station to the elevator/tether currently for this build as this was built just to showcase the BP/BLUEPRINT itself at the moment. Eventually this may be updated with a more decorated version with actual ground and orbital stations.
Due to mass balancing issues***** this is a single direction at a time track, either up or down. Due to said issue this whole build is odd number based/symmetrical. This is mostly so that the exact center of the entire build is aligned to the gravity of the planet.
*Game would not let me build anything taller past that point. **No joke, almost exact build cost just for the elevator/tether (not including the car) below. ***Anything that breaks all 4 rails in a 1km section will kill the rest of the elevator/tether above the break, and have it fall on the rest of it. ****You have to smooth and repair all breaks as the rail car will pretty much self-destruct if it hits anything. *****Initial build attempt was with a two track circular build that failed due to non-symmetrical shape of the cars and the mass not being centered properly due to this.
BUILDING COSTS ---Full Cost Coming Soon--- 1km Rail section is 4960 Light Armor Block at 25 steel plates a block for 124,000 Steel Plates just for 1km of rails.
LINKS TO THE BLUEPRINTS ---Coming Soon--- (fine-tuning design first)
Как установить и запустить
Откройте оригинальную страницу в Steam Workshop, проверьте версию игры, зависимости и порядок загрузки в описании автора. Нажмите «Подписаться» и дождитесь загрузки Steam. Включите материал в меню модификаций или контента игры, если это требуется. Совместимость и запуск редакцией не проверены.