Apollo(modless)
Фото и видео: 1 из 22. Материалы автора из Steam Workshop.
О материале
«Apollo(modless)» — материал мастерской Space Engineers. Моды, чертежи кораблей, скрипты и миры для Space Engineers. Данные Steam, описание автора и ссылка для установки через подписку. Совместимость редакцией не проверена.
Описание автора
Please open this blue print in a world with indestuctible block!!!!!!!!!
270m long 115m wide and height 16 hangar 8 large reactors 4 refinery, 16 assembler. All equiped with productive module. 144 large tank. 20 gatling turrets, 16 missle turrets.
All light armor.
Done with no mod.
HOW TO CONTROL THIS SHIP:
You should see four seats on the bridge.
Blue, red, yellow and brown.
BLUE one is the main control seat.
BLUE_PAGE 1
18. Group 18 gyro override control on/off;
9. Jump drive
RED one control all jump drive and oxygen system
RED_PAGE 1
1,3,5,7. Group 14 jump drive recharge on/off;
2,4,6,8. Group 14 jump drive protection hangar door open/close;
RED_PAGE 2
14. Group 14 oxygen generator on/off;
6. Oxygen tanks on/off;
8. All turrets on/off
YELLOW one control all the lights , reactors and antenna
YELLOW_PAGE 1 1.Bridge lights on/off; 2.Energy and production area lights on/off; 3.Living area lights on/off; 4.Hangar lights on/off; 5.Main tunnel lights on/off; 6.Top desk lights on/off
YELLOW_PAGE 2
1.Top desk gravity on/off;
2.Energy and production area gravity on/off;
47.Group 14 reactors on/off;
YELLOW_PAGE 3 1.All antenna on/off; 2.Increase antenna broadcast range; 3.Decrease antenna broadcast range; 4.Antenna broadcast on/off; 5.Show ship name on/off; 7.Beacon on/off; 8.Increase beacon range; 9.Decrease beacon range
BROWN one control all hangars
BROWN_PAGE 1
1.All hangar door open;
3.All hangar door close;
58.Group 14 hangar door open/close;
BROWN_PAGE 25
1.Hangar camera;
25. Hangar door open/close;
【I watched the vedio from last stand gamer, so, here is the instruction of that 3D printer~
3D_PRINTER
1.extend the piston by pressing the 3rd button. 2.open the projector by pressing the 2nd button. 3.open the welder by pressing the 1st button. 4.reverse the piston by pressing the 3rd button. 】
Hope you like this ship! If there is any question, just leave a message and I'll reply~
Как установить и запустить
Откройте оригинальную страницу в Steam Workshop, проверьте версию игры, зависимости и порядок загрузки в описании автора. Нажмите «Подписаться» и дождитесь загрузки Steam. Включите материал в меню модификаций или контента игры, если это требуется. Совместимость и запуск редакцией не проверены.