SG-A T22 Buzzard Tiltrotor VTOL - Modded - Hellothere_1
Фото и видео: 1 из 12. Материалы автора из Steam Workshop.
О материале
«SG-A T22 Buzzard Tiltrotor VTOL - Modded - Hellothere_1» — материал мастерской Space Engineers. Моды, чертежи кораблей, скрипты и миры для Space Engineers. Данные Steam, описание автора и ссылка для установки через подписку. Совместимость редакцией не проверена.
Описание автора
Summary
The SG-A T22 Buzzard is a four engine tilt rotor VTOL transport.
I build this as a proof of concept for several ideas I've been playing with for a while now.
My entry for the second planetary competition by Wastedspace.
Alternative Propulsion
The Buzzard does not use conventional Space Engineers thrusters. Instead it generates lift using player made propellers build from Digi's aerodynamic wing blocks that are powered by stock rotors.
The propellers are attached to hinged rotor pods which can be rotated forward to switch from vertical takeoff/ landing to forward flight using fixed wings. The plane can achieve airspeed of up to 70 m/s. This can be increased by changing the MaxVelocity constant in the script. However on my machine if I go above 80 rpm (current value) on Stable and above 90 rpm on Dev the rotor pods get increasingly likely to fall prey to Clang.
Due to the ridiculously high efficiency of rotors the Buzzard can fly for three full days on the charge of one stock small ship battery.
Fly By Wire System
The entire build does not use a single gyroscope. Instead an on-board programmable block runs a fly-by-wire script which grabs player inputs using the Control Module mod (also by Digi) and implements them by changing the thrust and angle of specific rotors.
In addition to that the plane also has a pair of aerodynamic rudders for yaw control during horizontal flight.
Stability Augmentation System
Due to the lack of gyroscopes the plane would under normal circumstances be extremely unstable and notoriously difficult to pilot. To prevent that the control script runs a proportional stabilizer on all three axes that detects unintended pitch/ yaw/ roll motions and automatically alters controls to apply a counter torque. In addition the script also uses an integral stabilizer on the pitch axis which prevents imbalances in the design from causing a slight pitch up/ down curve too slow for the proportional stabilizer to counter. The stabilizers can be disabled by setting the the Stabilizer constant of the control script to false. This will make the plane extremely hard to control though.
Controls
X: Engines On/Off (without engines on the control script won't run and nothing will work)
W,S: Pitch A,D: Yaw Q,E: Roll Shift: Rotate engine pods forward while pressed CTRL: Rotate engine pods backward while pressed Space: Increase thrust C: Reduce thrust
R: Toggle Landing Gear
P: Position Lights L: Spotlights
1: Open Doors 2: Close Doors 3: Toggle Ramp 4: Toggle Interior Lights
Since the craft uses a passenger seat as pilot seat (possible with Command Module) you can use the mouse to freely look around during flight.
You can read the controls on the left screen in the cockpit (which also provides feedback on current thrust, engine angle and landing gear status)
Additional Control Information
-
The script gradually switches between hover controls and forward flight controls as you rotate the engines forward, thus the plane remains controllable at any engine angle. Flying with the engines at 20°-30° inclination from vertical can be quite useful for the final approach towards a landing spot.
-
In vertical flight, descending at a rate of faster than 15-20 m/s causes the rotors to stall resulting in uncontrolled pitch/ roll maneuvers. If that happens immediately hold space to regain control.
-
Thrust control works differently in hover and forward flight. In hover flight if you don't press Space or C the thrust will always be at a preset value that is roughly the thrust required to counter gravity. While you hold Space or C the thrust will be at a higher/ lower level allowing you to accelerate upwards/ downwards. In forward flight ( engines at 90°) pressing Space or C will instead slowly increase/ decrease a persistent thrust variable. Space increases your speed, C slows you down and while not pressing a button the plane will keep it's current speed.
-
Since most controls are implemented via thrust vectoring, lowering the rotor speed too much will cause the steering to become increasingly unresponsive.
-
The landing gear is attached to the rotor pods. Thus it can only be out if the pods are completely vertical. Rotating the pods forward will automatically retract the landing gear. Extending the landing gear while mostly in hover flight (engine inclination less than 30° from vertical) will cause the engines to rotate back into hover position. Attempts to extend the landing gear while in forward flight (engine inclination >30°) get blocked.
General Information
The plane uses Whip's Artificial Horizon Script on a cockpit screen (see screenshot)
The main flight control script was written by me specifically for this build. In it's current state it is tied very closely to the plane's hardware, but in the future I might make a more general version which can be more easily used on custom planes.
Also, huge thanks to Inflex who helped me out with a code snippet able to extract a ship's angular velocities from a ship controller block after I asked for help on the forum. Find the exchange here. The code I received from him (last function in the program) is marked and credited inside the code.
Check out my Stargazer Foundation Design Thread over at the KSH forums.
Most content creators appreciate feedback.
Как установить и запустить
Откройте оригинальную страницу в Steam Workshop, проверьте версию игры, зависимости и порядок загрузки в описании автора. Нажмите «Подписаться» и дождитесь загрузки Steam. Включите материал в меню модификаций или контента игры, если это требуется. Совместимость и запуск редакцией не проверены.