3D Design Computer V1

Visit youtube.com/kangaming for more epic builds!

This is the first prototype of a 3D design computer system!

Controls:

There are 2 consoles on the computer, the design console and the save / load console. The design console is the console with the orange / brown buttons and 3 number display. The save / load console is the one with the memory block on it.

Design Console: Orange / Brown buttons - change position up or down (1-9) White button - set or reset the current selected pixel Red button - reset all pixels to 0

To Save: On the save / load console connect the 3 left connections to the memory block. Left orange number / blue logic / white number all should feed into the memory block. Turn on the green switch, keep red switch off. Press the green button.

To Load: On the save / load console connect the white connection and the right number connection. Right orange number feeds OUT from memory block. White number feeds into memory block. Blue logic should be disconnected from memory block. Left orange number is irrelevant (can be connected or not) Turn on both the green and red switches. Press the green button.

When you are saving or loading a design it will take approximately 4 minutes to read / write all the memory indexes. Do not touch anything while this is happening.

Version 2.0 will have a much simpler save / load system :D