RollerCoaster 2.0

This roller coaster does work but it's really complicated to setup so here is the most simple step by step instructions I could make for how to spawn it in and use it. Hope you enjoy playing with it. If you have any questions on how to use it ask me in the comments :)

HOW TO SETUP THE COASTER IN 4 STEPS PLEASE READ

1. When choosing a location make sure it is very flat as this will make things a lot easier

2. This model causes A LOT of lag so try to weld the model to the ground as fast as possible

3. once welded to the ground. Destroy the PINK STRIPED BLOCKS on the back of ALL 4 trains. These pink blocks connect the train to the track and need to be removed for the coaster trains to move.

DO NOT RUN OVER ANY SENSORS

4. After this the ride is good to go!

HOW TO OPERATE THE COASTER

SIMPLE CONTROLS

The green buttons is the dispatch button. This button launches the next train and tells it to leave the station. NOTE: If the gates and/or restraints on the train are open the ride will NOT launch

There are two green buttons one for the loading station one for the unloading station

ADVANCED CONTROLS (YOU DO NOT NEED TO USE THESE BUTTONS TO OPERATE THE RIDE)

The two BLUE buttons ON THE CONTROL PANEL control the gates in the station.

The two YELLOW/ORANGE buttons ON THE CONTROL PANEL are to open and close the restrains of the train.

The RED switch is the EMERGENCY STOP if this switch is on all the brakes around the ride will engage. (Turn the switch off to restart the ride)

SUPER ADVANCED CONTROLS (There is really no need to press these buttons)

The purple button is the reset button. It's resets the ride (Only press it if all trains are in the defualt blocks otherwise some fun collisions will happen)

The TEN blue buttons NOT on the control panel are to do with the block sections of the coaster. They act as almost ways to rick the sensors. WARNING!! PRESSING THESE BUTTONS CAN LEAD TO RANDOM STOPS AND TRAIN COLLISIONS!!