Liebherr 1000 EC-H - BIG Tower Crane V1

Liebherr 1000 ec-h 50 - BIG Tower Crane V1 Do you like it? Please give it thumbs up, make it your favorite and give a comment.

This is a Replica of one of the largest tower cranes in the world! Take the elevator or go all the way up to the top. Your own choice!

V2 (Mini): https://steamcommunity.com/sharedfiles/filedetails/?id=1759058664

How to control:

W: Spin the hook left S: Spin the hook right

D: Rotate the crane right A: Rotate the crane left

1 : Tilt seat (to see object on the ground)

2: Powerful counterweight (use carefully and smart)

3: Lower the hook (step one)

4: Lower the hook (step two)

5: Lower the hook (step three)

6: Lights in cabin

7: Lag fix (read explanation)

8: Close door in cabin

9: Drives the hook backwards (hold down key)

10: Drives the hook forward (hold down key)

Information and tips about the crane:

It is highly recommended that you weld the crane two blocks from the ground. Remember that this is a very large build. It takes about 10-15 seconds to release it from the lift. And about the same time to weld it to the ground. This time differs depending on what computer performance you have. Give it time, It's worth it! ;-)

What is Lag fix?

When the green light in cabin is lit, it is active. Or activate at the bottom of the crane when it's released from the lift. Thrusters is placed under the crane to reduce the weight on the ground. Thrusters is also placed at the end of the crane arm because when the cranearm is lifted it reduces the loss of frames effective.

How to lift a heavy object?

When you lift a heavy object you have to use counterweight, lag fix or both of them at the same time. The use of them can be said to be a balancing act. But you will learn that quickly after some lifting. It's recommended that the crane is welded to the ground when it's used for heavy lifting.

Dose it have any weak point?

The weak point on the crane is the rotation. Only one bearing! So when you rotate the crane you have to check carefully so that it does not start to swing or get caught.

---

It took me a very long time to do this creation. I hope it will be to your satisfaction. Happy lifting! :D

If you want to do upgrades on my creations that is ok. But if you upload it to the workshop i hope that you mention who built the original. Thanks!

Check out my Komatsu wheel loader build: https://steamcommunity.com/sharedfiles/filedetails/?id=1721110251

Made by Robb (Robert L.)