Mikasa 2020

Upgrade 2020-03-13

Finally, after 3 years, I completely overhauled my beloved little spaceship to its third version. Back then there were no pistons, so I had to use many laggy bearings. Finally the lags are gone! The gyroscope got modernized to the latest standards, including a reset function and tilted sensors for more precision. The gyroscope can now be deactivated and instead the ship can be tilted manually, which gives much more control overall! I also gave a decent face lift to my new best build.

Still, no mods or glitches - all vanilla.

Learn how to handle it, after that... enjoy! Also, give credit if you show it or change and re-release it since it was a hell lot of work (about 60-70 hours including V1 and V2)!

---

Controls:

WASD - basic driving and flying

1 - Entrance 4 - Landing gear

2 - Up 3 - Down

5,6,7,8 - Tilt controls, will only work when gyro and the balancing system is deactivated 9 - reset gyro, switch between gyro balancing and manual tilt mode

0 - Switch hovering on and off, will be needed to raise; consider it a start button to take off

---

Tips:

• When the shuttle remains tilted, hit 9 to go to manual mode, lay your hand on the keys 5-8 and try getting it balanced again. Then hit 9 again - the now reset gyro will try to keep balancing again.
• When accelerating after turning, the ship sometimes tilts to the front. In this case release the W key and let the gyro do its job first, or stabilize with 7 in manual mode.
• Since we can only use 10 extra controls I had to leave the lights disconnected from the seat. You can turn them on from inside the ship on the middle white switch.
• Going up and down shares the thrusters with the balancing system. I had to turn down their power completely, because otherwise the balancing freaks out and always tilts the ship too much. As a result, going down is extremely slow, so you better turn off the hovering (0) completely. Don't forget turning it back on before crash landing!
• The mechanism for going forward and backward in air by hitting W and S is not perfect. Sometimes it doesnt work, but you can fix it by just alternately hitting W and S. You can see if the mechanism works by looking through the left window from outside. It is located in front of the left seats and you should be able to see the lights of the sensors if it works.
• Do not pull out your connecting tool when standing inside the ship - you have been warned xD