Kongsmetall M28 I4 Engine & Transmission

General Info:

The Kongsmetall M28 is a heavy duty petrol engine in an inline 4 config. This engine comes with a fully working transmission including a gearbox and clutch! This engine is fully mechanical and utelizes actual pistons and has lots of nice features making this perfect for trucks, tractors, generators and large cars.

The creation comes with 2 engines, one in the classic red and another in a blueish green :D

Note: I will allow uploads of vehicles with this engine, but you will have to either put me as a creator or credit me in the description, if not then i will report it as a reupload to steam moderators as usual :P

User manual:

First step is to start the engine by pressing x once. Second step is to engage the clutch by holding down W. W is also the keybind for the forward gear and throttle. To switch it into reverse, release w and hold x until the shifter is clearly in reverse, then proceed to throttle the engine.

Innstallation manual:

To install the engine, connect the driveshaft of your vehicle to the output of the transmission. And then proceed to attach the oilpan or engine block to the vehicle frame.

I would reccomend you to add some sort of gear ratio when installing the engine, this can be done with a sprocket and idler, but it isnt absolutely required.

If more power is needed then simply increase the power of the thrusters!

Other:

as far as i am aware i believe this is the most realistic thruster powered engine on the workshop, i found this really fun to make and i hope you can have fun with it too!

The absolute minimum fps requirement for this engine is 45fps and the reccomended is 100+, the higher, the better it will run, therefore i reccomend using this in private servers with few people.

A challenge for someone interested is to make a fully realistic drive shaft and frame for this engine, could be fun to do.