Easy Fire Suppression System

A wiring setup that puts out fires. If fire is detected it will pump water in until the fire is extinguished. Then it will pump water back out again until the room is drained.

Useful near the reactor, but can also be used to safely grow pomegrenades.

This can be retrofitted onto vanilla subs.

An alternate, simplified version can be made that only uses 1 component: a smoke detector. I do not recommend the 1 component version. If you still want to use it just wire the smoke detector to the set_targetlevel pin on the pump and set -100 false 100 true. I don't recommend this version because it wont always work if the hulls between where the pump is and the fire starts are not linked. This is up to the subbuilder. A good example of a spot where the 1 component version will not work is the research area of the Winterhalter. Targetlevel would only fill the lowest room where the suits are, not overflow them. The 4 component version would still work. The 1 component version also drains slightly more power because the pump has to be in standby all the time. If you do the same thing but connect it to set_speed instead it will drain tons of power. The pump will be operating at full speed always, even when there is nothing there to pump.